![]() ![]() To do so, scan the barcode below directly from your iPad's screen. To use your barcode scanner and keyboard at the same time in the Retail POS app, you need to set it to Bluetooth MFi_SSI mode. By default, your barcode scanner is set to the HID keyboard mode.To reset your barcode scanner to factory defaults, scan the barcode below directly from your iPad's screen:Ģ. Pair your barcode scanner with your iPad.Under MY DEVICES, tap the information icon to the right of your barcode scanner.On your iPad, tap Settings > Bluetooth.Reset your barcode scanner to factory defaults If you do, however, make sure to not stretch them in the printing process as it'll make it unscannable. The barcodes are also included in Zebra's CS4070 Scanner Product Reference Guide that came with your barcode scanner.ġ. Note: If scanning the barcodes in this setup directly from your iPad's screen doesn't work, try printing this Help article and scanning the printed copy of the barcodes instead. Pair your barcode scanner with your iPad.Reset your barcode scanner to factory defaults.Scan the pairing barcode to pair the scanner and cradle.If you're having issues pairing your Zebra CS4070 barcode scanner to your iPad: The cradle is no longer connected to the barcode scanner but it will charge the barcode scanner. Battery is above or below normal operating temperature.Ĭradle is externally powered and connected to a USB host interface which has suspended the cradle. ![]() The scanner can remain in the cradle while the battery warms or cools to normal operating temperature.Ĭritical battery temperature fault. If this occurs, do not use the barcode scanner and move the barcode scanner to a location within normal operating temperature. Battery is above or below normal operating temperature. The following charts detail the Scanner and Cradle LED definitions. If you reboot the PC and the green light appears on the scanner cradle before Windows finishes booting up and then turns off again, try scanning the HID USB host-type barcode below while the computer is booting up and the green light is still appearing on the cradle. If you are unable to scan any of the barcodes above try printing the LI4278 Quick Start Guide.Ĭradle has no light but temporarily presents a light when the PC is rebooted If you can't scan large cartons or case barcodes please scan this barcode to activate. ![]() To add an Enter key after scanned data, please scan all three bar codes in numerical order.
0 Comments
Leave a Reply. |